A 67→77 step-up ring screws its 67 mm side into the lens and presents a 77 mm filter thread.
Make the exact-model decision
Confirm both threads are ordinary screw-in types; test hood fit and wide-angle corners afterward. Locate the exact lens front-thread size in its manual or spec table, then verify whether the accessory is screw-in, magnetic, square-holder or drop-in.
A manufacturer example
Tamron lists model A063 in distinct Sony E and Nikon Z mount versions, both with a 67 mm filter thread. A common marketing name does not make them the same physical part. Use the linked page for its stated model and revision; a different model may need a different support document.
Where to draw the line
Thread arithmetic can identify a ring direction, but it cannot certify hood clearance or an image without corner shading. If a source does not address the exact feature you need, record that feature as unknown rather than treating silence as support or incompatibility.
Your next step
Take the model code from the body or lens label, open the official source below, and compare its scope with the equipment you have. Then use the calculate a filter route to organize what is known. Do not mount an item that resists or appears on a maker’s exclusion list.
Official sources and scope
Checked for this reference on October 30, 2026. Product firmware and support lists can change; inspect the current maker page for your exact revision.