Leica Summicron-M 35 f/2 ASPH. is listed for Leica M with Full frame coverage. A front screw-in filter size is not established by the checked evidence, so no diameter is recommended. The supplied research links this exact mount variant to manufacturer evidence. Body-specific AF, crop and adapter behavior remain separate checks.
As an Amazon Associate I earn from qualifying purchases.
Verified specifications
| Field | Value |
|---|---|
| Maker model code | 11673 |
| Mount | Leica M |
| Image format | Full frame |
| Front filter thread | Not specified in checked source |
| Model ID | leica-summicron-m-35-f-2-asph-leica-m |
| Focal length | 35 mm |
| Maximum aperture | f/2 |
| Weight | 8.9 oz (approx.; 252 g maker value) |
| Length | 1.41 in (approx.; 35.7 mm maker value) |
| Maximum barrel diameter | 30.7 mm |
| Closest focus | 2.30 ft (approx.; 0.7 m maker value) |
| Maximum magnification | 0.05747× |
Compare camera lenses listings
Compare the exact model code and rear mount in each listing. Amazon results may contain another mount or generation; the search is not a compatibility verdict.
(paid link)
Search camera lenses on AmazonChoosing a camera
Look for the Leica M designation on the camera specification, then verify the exact model code and mount variant against its support page. The maker lists a 35 mm focal range and f/2 maximum aperture. A physical mount match is a starting point; still AF, movie AF, crop behavior, stabilization and firmware need separate checks.
Choosing a filter
A circular screw-in filter with a matching documented thread size is only a mechanical candidate. Magnetic filters, wide frames and stacked rings need separate system and vignetting checks. When no front thread is specified, do not buy a size from the focal length or barrel diameter.
This model cannot enter the diameter calculator until a verified front thread or dedicated holder specification is available.
Keep exploring
Official sources and scope
Checked for this reference on October 30, 2026. Product firmware and support lists can change; inspect the current maker page for your exact revision.