OM SYSTEM M.Zuiko Digital ED 150-600mm F5.0-6.3 IS is listed for Micro Four Thirds with Micro Four Thirds coverage. A front screw-in filter size is not established by the checked evidence, so no diameter is recommended. The supplied research links this exact mount variant to manufacturer evidence. Body-specific AF, crop and adapter behavior remain separate checks.
As an Amazon Associate I earn from qualifying purchases.
Verified specifications
| Field | Value |
|---|---|
| Mount | Micro Four Thirds |
| Image format | Micro Four Thirds |
| Front filter thread | Not specified in checked source |
| Model ID | om-digital-solutions-m-zuiko-digital-ed-150-600mm-f5-0-6-3-is-micro-four-thirds |
| Focal length | 150–600 mm |
| Maximum aperture | f/5–6.3 |
| Weight | 72.8 oz (approx.; 2065 g maker value) |
| Closest focus | 1.84 ft (approx.; 0.56 m maker value) |
| Maximum magnification | 0.35× |
Compare camera lenses listings
Compare the exact model code and rear mount in each listing. Amazon results may contain another mount or generation; the search is not a compatibility verdict.
(paid link)
Search camera lenses on AmazonChoosing a camera
Look for the Micro Four Thirds designation on the camera specification, then verify the exact model code and mount variant against its support page. The maker lists a 150–600 mm focal range and f/5–6.3 maximum aperture. A physical mount match is a starting point; still AF, movie AF, crop behavior, stabilization and firmware need separate checks.
Choosing a filter
A circular screw-in filter with a matching documented thread size is only a mechanical candidate. Magnetic filters, wide frames and stacked rings need separate system and vignetting checks. When no front thread is specified, do not buy a size from the focal length or barrel diameter.
This model cannot enter the diameter calculator until a verified front thread or dedicated holder specification is available.
Keep exploring
Official sources and scope
Checked for this reference on October 30, 2026. Product firmware and support lists can change; inspect the current maker page for your exact revision.